CALL US: 866-375-4500 (M - F, 9am - 5pm EST)

Put Away Your Hammer

 

Not all of us can walk through our home with hammer and nails in hand. If your lease or dorm rules prohibit you from nailing up drapery brackets you need to find a get creative. One solution would be to use a tension rod from Umbra which will allow you to hang lightweight curtains without mounting hardware. You can also use tmporary hook. The kind that stick on the wall and then remove with out damage. As long as your window treatments are not too heavy, either method you select will be adequate for holding up the hardware.

To install a tension rod, measure the length and width of the inside of the window frame. Choose a curtain made from lightweight fabric. The length should ideally be equal to or slightly shorter than the length of the inside of the window frame. The width can vary, depending on how much fullness you desire. Tension rods are adjustable within a certain range. Be sure to pick the longest rod that will fit in your window to ensure the greatest amount of spring tension to keep the rod secure. Turn the end sections of the rod to change the length, making it slightly less wide than the window opening.Slide the curtains on and then place the rod near the top of the wiindow frame at a spot where the hem of the curtain will brush the window sill.

If you decide to uses temporary hooks, attach them as you would nails – one on each corner of the window just outside the frame. It’s best if you leave the hooks in place for about an hour to let the adhesive set up. When picking curtains for this application, make sure the weight of the fabric does not exceed the combined weight of the two hooks.

Sometimes a sheer curtain or one that is lightweight enough to hang from either of these two methods isn’t quite enough. Designed to cling to your window through the use of static electricity, window cling film from Etch Art is completely removable and reusable. Installation is easy. Just wash the window, trim the film to size and apply a layer of water to the window. Place the film against the window and squeegee away any excess water and air. Add a decorative touch or use privacy films to help keep any eyes from looking in.

Now there’s no excuse to be stuck with boring apartment or dormitory vertical blinds ever again. Put away your useless hammer and get out your ruler or tape measure and get to work!

Leave a Reply

Your email address will not be published. Required fields are marked *

*